Need help?Do you have a question about the ADVANSEA WIND S400 and is the answer not in the manual?
Details on NMEA 0183 input and output interfaces for data communication.
Guidance on physically installing the WIND/WIND-a S400 unit on a boat.
Details of electrical connections including bus and sensor wiring.
Instructions for connecting sensors, power, and NMEA sources.
Overview of the S400 display features, screen, and analogue display.
List of standard components supplied with the WIND/WIND-a S400 display.
Detailed technical specifications for measurement, electrical, and environmental aspects.
Instructions on how to power on the WIND/WIND-a S400 display unit.
Guide to operating the display in normal mode, including wind type and data selection.
Information on alarm indicators and how to set wind speed and battery voltage thresholds.
Details on filtering, calibration, simulation mode, key beeps, and memory reset.
How to place the WIND display on standby to save energy.
Information on connecting and exchanging data between advanSea instruments via the AS-1 bus.
Explanation of event messages like Err Bat, Err MEM, and Err Bus.
Common causes and solutions for the unit failing to power on.
Troubleshooting steps for wrong or incoherent wind speed and direction data.
Explanation for the SIMU flashing icon and incoherent readings displayed.
To Next Page
General