Advantech USC-360 Startup Manual

4 USC-360 Startup Manual
2. Plug Type-C cable to Type-C IO used for DP in USC-
360.
3. Integrated 2nd display stand and USC-360 stand with
the hook and hole in the stand base.
ShortSidePeripheralInstallation
1. Remove peripheral cover in side.
 InstallationProcedures(Cont.)
2. Plug MSR/Scanner/RFID module into USB connector
in USC-3.
3. Install the module and secure with 2pcs screws.
InstallScanneronIOSide
1. Remove cable cover.
2. Plug Scanner module into USB connector in USC-360.
3. Install the module and secure with 2pcs screws.
 InstallationProcedures(Cont.)

Advantech USC-360 Specifications

General

Brand	Advantech
Model	USC-360
Category	Touch terminals
Language	English