Advantek Networks ANS-24RV - 3 Console User Interface; Connecting to the Switch Console Port; Setup Hyperterminal

28 pages

To Next Page

To Previous Page

3. Console User Interface

3.1 Connecting to the Switch Console Port

User can configure the switch system via terminal emulation program through RS-232

port with baud rate 19200-8-n-1. The RS-232 connector is on the back panel of the switching

hub; make sure you connect the other end of serial port to COM1 of PC.

Note: When you use HyperTerminal with MS Windows 2000, make sure that you have

Windows 2000 Service Pack 2 or later are installed. Otherwise the arrow keys do not

function properly under HyperTerminal’s VT100 emulation.

3.2 Setup HyperTerminal

Please follow the steps to setup the HyperTerminal:

Step 1: Click Start Æ All Programs Æ Accessories Æ Communications Æ

HyperTerminal.