2 Select “Obtain an IP address from DHCP server”. If there is a DHCP server on your network.
This option allows the print server to obtain IP-related settings automatically from your
DHCP server. This setting, by default, is disabled. If you would like to manually specify an IP
address to the device, please skip to the following step.
3 In the IP Address option, type an IP address for the print server. The IP address must meet the
IP addressing requirements of the network segment.
4 (Optional) In the Subnet Mask option, type the Subnet Mask your LAN or network segment is
currently configured to use.
5 (Optional) In the Gateway field, type the IP address of gateway.
6 When done, click OK button. The program will save the above settings into the print server.
7 Done
NetWare Wizard
1. Log into your NetWare file server as a Supervisor (Admin.) or equivalent.
2. Click Wizard button just like a picture ＜
＞.and select NetWare Wizard, as follow picture.
To Next Page
Loading...