Need help?Do you have a question about the Adventure Kings A5 and is the answer not in the manual?
General| Brand | Adventure Kings |
|---|---|
| Model | A5 |
| Category | Monitor |
| Language | English |
Calibrate HUD speed to match vehicle odometer, adjusting for discrepancies. Default 107, range 80-120.
Set an audible alarm for exceeding a specified speed. Configurable range 10-180 km/h or mph.
Adjust display brightness from 0 (automatic) to 5 (brightest). 1 is faintest.
Select display unit for speed: 0 for km/h, 1 for MPH. Range is 0-1.
Set voltage threshold (100-150V) for automatic power-off to prevent battery depletion.
Choose display mode: 0 for projected data, 1 for direct speed reading on unit.
Procedure to reset the HUD to factory default settings using the switch.
Troubleshoot why the HUD is not lighting up when plugged in and the car is started.
Ensure correct speed units are used and calibrate speed to match odometer.
Tips for improving projected image clarity, including using reflective film or adjusting brightness.
Connect the HUD to the cigarette plug and position it for optimal viewing.
Using the protective film ensures a sharper projected image and readability.
Steps to clean the area, apply the film, and remove air bubbles for clear projection.
To Next Page
