EasyManua.ls Logo

Adventure Kings CYCLONE DRONE User Manual

Adventure Kings CYCLONE DRONE
10 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Safety Precautions
1. To ensure the requirements of the electromagnetic environment of aeronautical radio
station (stations).
It is forbidden to use various model remote controllers in an area with a radius of 5000m
centred on the airport runway centre point. The model remote controller shall be stopped
as required during the release of radio control orders by the relevant state agencies in the
area.
2. Choose warm, sunny and windless weather. Don’t y in bad weather conditions such as
overheating, coldness, strong winds, heavy rain, etc. Choose indoor or outdoor open areas
and keep safe distances with people, pets, airlines and other obstacles. Conrm that no
other users use the same frequency; do not allow the aircraft to leave your line of sight.
3. After the aircraft has started, do not touch the high-speed rotating part of the aircraft and
keep your distance from the high-speed rotating propellers to avoid the danger of an injury
(including gears, rotors, etc.)
4. When the aircraft is in use and after use, the batteries and motor will generate high
temperatures. Do not touch them to avoid the risk of burns.
5. Do not look directly at the LED light beams to avoid aecting the eyes.
Question and Answer IconNeed help?

Do you have a question about the Adventure Kings CYCLONE DRONE and is the answer not in the manual?

Adventure Kings CYCLONE DRONE Specifications

General IconGeneral
GPSYes
Obstacle AvoidanceNo
Max Speed40km/h
Follow Me ModeYes
Return to HomeYes
Battery7.4V LiPo

Summary

Drone Safety Precautions

Electromagnetic Environment Safety

Avoid using remote controllers near airports to prevent interference with aeronautical radio stations.

Weather and Flight Conditions

Fly in warm, sunny, windless weather; avoid bad conditions and maintain safe distances from people and obstacles.

Rotating Parts Hazard

Keep distance from high-speed rotating propellers and gears to avoid injury after the aircraft has started.

Thermal Hazards

Avoid touching hot batteries and motors during and after use to prevent the risk of burns.

LED Light Safety

Do not look directly at the LED light beams to avoid affecting your eyes.

Pre-Flight Preparation and Environment

Indoor Flight Environment

Prefer spacious indoor spaces away from barriers, crowds, or pets for optimal flight.

Outdoor Flight Conditions

Prefer sunny, windless, and breezy weather for outdoor flights.

Obstacle and Distance Guidelines

Keep the drone in sight and away from barriers, high-tension cables, trees, and people.

Extreme Environment Avoidance

Do not fly in extreme hotness, coldness, strong winds, or heavy rain.

Blade Replacement and Safety

Correct Blade Installation

Ensure blades A and B are installed in their corresponding positions for proper drone control.

Blade Rotation Direction

Blade A rotates clockwise, and Blade B rotates counter-clockwise during flight.

General Flight Safety

Fly in safe areas, avoid maneuvering over crowds, and be aware of operational errors or interference.

Age and Experience Recommendation

Recommended for users over 14; assistance from experienced pilots is advised for learning.

Remote Control and Charging

Remote Control Button Functions

Introduction to the functions of buttons like Headless Mode, 3D Roll, Joysticks, and Take Off/Landing.

Remote Controller Assembly

Install two AAA alkaline batteries following polarity; do not mix new and old batteries.

Aircraft Battery Charging Safety

Use supplied charger, follow polarity, avoid short circuits; recharge non-rechargeables under supervision.

Flight Procedures

Initial Flight Setup

Unfold the remote, power on the drone, and perform the initial joystick sequence for preparation.

Take Off Methods

Two methods described: simultaneous joystick movements for calibration then button press, or joystick start then throttle.

Landing Methods

Two methods: throttle lever control for normal landing, or button press/rapid throttle down for emergency landing.

Flight Control and Fine Tuning

Basic Flight Controls

Control ascending/descending, turning, and forward/backward movement using the left and right joysticks.

Advanced Flight Adjustments

Utilize side fly, fine tuning, and fine adjustment for forward/backward motion via joystick and throttle.

Headless Mode Operation

Fly based on remote direction, not drone nose orientation. Enter/exit with specific button presses and sounds.

Reset and Recalibration

Reset drone if hovering unevenly by turning off/on and performing joystick calibration sequence.

Practice, Calibration, and Tips

Basic Flight Practice

Practice throttle control for smooth takeoff/descent and joystick control for directional movement and turning.

3D Roll Operation

Perform thrilling 3D rolls by pressing the 3D roll button and moving the right joystick in desired directions.

Hovering Calibration

Calibrate if the drone hovers unevenly by holding joysticks in lower right and left corners for 4 seconds.

Pre-Flight and Environment Tips

Ensure a level surface, choose safe indoor/outdoor locations, and fly in calm, non-breezy weather.

Weather and Wind Precautions

Avoid extreme weather and strong winds, as they can affect flight performance or cause damage.

Troubleshooting and Precautions

Aircraft Response Issues

Address non-response, low sensitivity, or drifting by checking remote battery, quality, and recalibrating.

General Operational Precautions

Maintain sufficient power, avoid low power flight, handle damaged aircraft safely, remove batteries when idle, protect transmitter.

Mobile App Client Installation

Scan QR codes to download the companion mobile APP for iOS or Android devices.

Mobile App Device and Interface

Adding the Drone Device

Turn on product power, connect to device's WiFi hotspot via phone settings, then open the APP.

App Interface Icon Functions

Explains the functions of icons for Left and Right Throttle controls within the drone's mobile application.

Warranty Information

Warranty Period and Coverage

Provides a 12-month warranty against manufacturing defects and details what products and conditions are covered.

Warranty Exclusions

Lists damages and issues not covered by warranty, such as improper use, faulty installation, or transit damage.

Warranty Claim Procedure

Provides a phone number for warranty claims and lists contact details for the service provider.