Adventys Induct-NoLimit MO4NL 16000 - Configuration Management; Saving and Recalling Configurations

36
EN
-

Press the SELECTION key for the zone you want to adjust, then press the [P / T] key and then use the encoder to select
the desired temperature. By default the seng of a zone is made in power.
The P or T ° led indicates the current seng mode: P for power and T for temperature.

Set each zone in a conguraon you wish to memorize. Press the [] key for 3 seconds unl the 3 LEDs ash.
Then select with the encoder the desired memory program (1 or 2 or 3). Then, without any acon on your part for 3
seconds the new conguraon will be memorized.

Press the memory buon [] briey and select with the incremental encoder one of the 3stored programs (1or2or3).
Then, without any acon on your part for 3 seconds, the sengs of the stored program will be sent.
-
-