42
…
A luminous display appears when the
unit is switched on.
Normal funconing NOTHING: It is normal.
During commissioning, your system
switches o.
The connecon of your device is
faulty.
Check your connecon or the
conformity of the connecon.
Venlaon connues a few minutes
aer your unit is turned o.
Cooling of the electronics.
It is normal.
The device does not work. The
indicator lights on the keypad remain
o.
The unit is not powered. The power
supply or connecon is defecve.
Inspect fuses and circuit breaker
of your electrical installaon.
An "F-" indicaon is present on
the product display.
There is a permanently acvated key
on the control keypad
If the defect does not disappear, do
call the Aer-Sales Service.
The unit does not work, an error
message "Fx" or "Hx" is shown on the
display and the power is stopped.
The electronic circuits work
badly.
Unplug and then plug the product
back in if the problem persists.
Call the Aer-Sales Service
Department.
The unit emits an odor during the rst
few rings.
New device.
Operate the unit for 1/2 hour without
load.
-
The air lters located on the front of the furniture should be cleaned regularly with soapy water, depen-
ding on the level of air polluon inside the kitchen. The cleaning period can range from every 2 weeks
to every 2 months.
Once the lters have been cleaned, they must be put back in place completely dry before any new use.
The air lters protect all components inside the cabinet from dust and grease. They are essenal for
ltering the fresh air needed to cool all the components and electronic boards that operate the cabinet.
There are 10 square air lters that are posioned and accessible on a front plate inside the cabinet.
These lters lter the fresh air for the 4 electronic generators.
There are 2 air lters of rectangular shape which are present and accessible on the high front part, just
above the control panels. These lter the fresh air for the 16 inductors.
To Next Page
Loading...