6 - 10
IS725AN-1 Rev. 110908-0
Assembly Instruction Manual
Switch with FUEL engine cranking
Code 725A
Description of basic functions
English
Safety device
BUTTON
YELLOW LED
TWO-COLOUR
RED/GREEN LED
3 GREEN LEDS
G 1/4
2/4 3/4 4/4 o B
Use on injection vehicles with electronic reduction gear•
Reprogrammable:•
- Can be set with fuel cranking and changeover during DECELERATION (default set-
ting) or changeover during ACCELERATION
- Possibility to be used with different sensor types:
- A.E.B.
- 0÷4700 Ohm
- 0÷90 Ohm
- RESERVE
- Rev reference for the modifi able changeover
NOTE: if the switch is installed on a vehicle having the Timing Advance Proces-
sor code 549N, it is necessary to connect the BROWN switch wire to the BLACK
Timing Advance Processor wire.
Built-in Safety-Car device for enabling the GAS solenoid valves only with the engine •
running, activates automatic GAS delivery blocking within 1 second from the accidental
switching off of the engine.
Installation
Can be installed using the support bracket included in the package •
Can be installed fl ush-mounted in the dashboard using the heat cutter (to be requested •
separately)
NOTE: The switch is supplied without sensors, so in order to get indication of
the fuel level you have to request the relevant sensor (METHANE or LPG) sepa-
rately.
IS725AN-1.indd 6IS725AN-1.indd 6 11/09/2008 9.11.1711/09/2008 9.11.17
To Next Page
Loading...