AEE Aerial Photography Equipment
Professional·Advanced
- 7 -
Points for attention:
(1) The propellers are designed with automatic tightening function; please do not over-tighten them during
installation, and do not use screw adhesive.
(2) Please make sure the propellers with black and silver caps are installed in right positions.
(3) Since the propeller blades are thin, it is suggested that gloves should be worn during installation in order to avoid
accidental injury.
(4) Please check if the propellers and the motors are properly and firmly installed before each flight.
(5) Please check if all propellers are in good condition before each flight; in case of ageing or damage, please
replace the propeller(s) in question before flight.
(6) Please do not get close to rotating propellers or motors to avoid cutting injury.
A propeller with black cap should be
installed on a support arm with “P” mark.
To Next Page
Loading...
