15
15
BATTERY AND CHARGER
Compatible battery pack
(not included)
Compatible charger
(not included)
L1820R
L1820S
L1825R
L1830R-X5
L1840R
L1850R
L1860R-X5
L1890R
AL18G
BL1218
BLK1218
BL18DPS
BL18S
Use AEG 18V battery and charger only
WARNING!
Read all safety warnings, instructions, illustrations and
specifications provided with this power tool. Failure to follow
all instructions listed below may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future reference.
INFLATOR SAFETY WARNINGS
Risk of bursting. Do not preset the product resulting in its output
pressure to be greater than the marked maximum pressure of the
item to be inflated. Do not use at pressure greater than 150 PSI (10.3
bars).
Make sure the hose is free of obstructions or snags. Entangled
or snarled hoses can cause loss of balance or footing and may be
damaged.
Never leave the product unattended with the hose still connected and
operating.
Never leave the product unattended with the nozzle attached to the
item being inflated.
To reduce the risk of electrical shock, do not put the product in water
or other liquid. Do not place or store an appliance where it can fall or
be pulled into a tub or sink.
Do not continue to use the product or nozzle which leaks air or does
not function properly.
Do not attempt to pull or carry the product by the hose.
Store indoors.
Always disconnect the air and power supply before making
adjustments and servicing, or when not in use.
Inspect yearly for cracks, pin holes or other imperfections which could
cause the product to become unsafe. Never cut or drill holes in the
product.
Know your inflator. Read operator’s manual carefully. Learn its
applications and limitations, as well as the specific potential hazards
related to this tool. Following this rule will reduce the risk of electric
shock, fire, or serious injury.
To reduce the risk of electric shock, do not expose the product to
rain. Store indoors.
Never cut or drill holes in the product.
Use the product only for its intended use. Do not alter or modify the
TECHNICAL DATA HIGH PRESSURE INFLATOR
A18HPI
Rated voltage 18 V
High pressure flow rate
@ 90psi 14 L/min
@ 35psi 23 L/min
Maximum pressure 150 PSI, 10.3 BAR
Pressure hose length 51 cm
Weight - not including battery pack 1.05 kg
Measured values determined according to EN 62841.
A-weighted sound pressure level L
= 89.0 dB(A)
Uncertainty K 3 dB(A)
A-weighted sound power level L
WA
= 100.0 dB(A)
Uncertainty K 3 dB(A)
Wear ear protectors.
The vibration total values (triaxial vector sum) determined according to EN 62841:
Vibration emission value A
h
= 4.0 m/s
2
Uncertainty K 1.5 m/s
2
WARNING
The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 62841 and
may be used to compare one tool with another. It may be used for a preliminary assessment of exposure. The declared vibration emission level
represents the main applications of the tool. However if the tool is used for dierent applications, with dierent accessories or poorly maintained,
the vibration emission may dier. This may significantly increase the exposure level over the total working period.
An estimation of the level of exposure to vibration should also take into account the times when the tool is switched o or when it is running but
not actually doing the job. This may significantly reduce the exposure level over the total working period.
Identify additional safety measures to protect the operator from the eects of vibration such as: maintain the tool and the accessories, keep the
hands warm, organisation of work patterns.
To Next Page
Loading...
