12.2 How to remove: Shelf
supports / catalytic panels
Remove the shelf supports / catalytic
panels to clean the oven.
Step 1 Turn off the oven and wait un‐
til it is cold.
Step 2 Pull the front of the shelf sup‐
port away from the side wall.
Hold the rear of the shelf sup‐
port and catalytic panel in
place. The catalytic panels
are not attached to the oven
walls. They can fall out when
you remove the shelf sup‐
ports.
Step 3 Pull the rear end of the shelf
support away from the side
wall and remove it.
Step 4 Install the shelf supports in
the opposite sequence.
12.3 How to use: Catalytic
cleaning
There are catalytic panels in the cavity. It
absorbs fat during catalysis.
Spots or discolouration of the catalytic
coating have no effect on the cleaning.
Before the catalytic cleaning
Turn off the oven and wait
until it is cold.
Remove all accessories. Clean the oven floor and the
inner door glass with warm
water, soft cloth and mild de‐
tergent.
Clean the oven with catalytic cleaning
Step 1 Step 2 Step 3
Set the function and the
oven temperature:
250 °C
Duration: 1 h
After cleaning, turn the knob for
the oven functions to the off po‐
sition.
When the oven is cold,
clean the cavity with a wet
soft cloth.
www.aeg.com24
To Next Page
Loading...
