6.3 Setting a heating function
1. Turn the knob for the heating
functions to select a heating function.
2. Turn the control knob to select the
temperature.
The lamp turns on when the oven
operates.
3. To turn off the oven, turn the knobs
to the off position.
6.4 Setting the function:True
Fan Cooking PLUS
This function allows to improve humidity
during the cooking.
WARNING!
Risk of burns and damage to
the appliance.
Released humidity can cause burns:
• Do not open the oven door when the
function operates.
• Open the oven door with care after
the function stops.
Refer to “Hints and tips”
chapter.
1. Fill the cavity embossment with tap
water.
The maximum capacity of the cavity
embossment is 250 ml.
Fill the cavity embossment with water
only when the oven is cold.
CAUTION!
Do not refill the cavity
embossment with water
during cooking or when
the oven is hot.
2. Put food in the oven and close the
oven door.
3. Set the function: .
4. Press the Plus Steam button .
The Plus Steam button works only
with this function.
The indicator turns on.
5. Turn the control knob to select a
temperature.
6. To turn off the oven, press the Plus
Steam button , turn the knobs to
the off position.
The indicator of the Plus Steam button
turns off.
7. Remove water from the cavity
embossment.
WARNING!
Make sure that the oven
is cold before you
remove the remaining
water from the cavity
embossment.
6.5 Fast Heat Up
The fast heat up decreases the heat up
time.
Do not put food in the oven
when the Fast heat up
operates.
1. Turn the knob for the oven functions
to set the fast heat up.
2. Turn the knob for the temperature to
set the temperature.
The signal sounds when the oven is at
the set temperature.
3. Set an oven function.
6.6 Heat-up indicator
When the oven function operates, the
bars in the display appear one by one
when the temperature in the oven
increases, and disappear when it
decreases.
www.aeg.com
10
To Next Page
Loading...
Need help?
General
