Step 1 Turn off the oven and wait un‐
til it is cold.
Step 2 Pull the front of the shelf sup‐
port away from the side wall.
Step 3 Pull the rear end of the shelf
support away from the side
wall and remove it.
Step 4 Install the shelf supports in
the opposite sequence.
11.3 How to use: Pyrolytic
cleaning
Clean the oven with pyrolytic cleaning.
WARNING!
There is a risk of burns.
CAUTION!
If there are other appliances
installed in the same
cabinet, do not use them at
the same time as this
function. It can cause
damage to the oven.
Before the pyrolytic cleaning:
Turn off the oven and
wait until it is cold.
Remove all accessories and
removable shelf supports.
Clean the oven floor and the in‐
ner door glass with warm water,
a soft cloth and a mild deter‐
gent.
Step 1
Set the function: . - flashes.
Step 2 Turn the control knob (for the temperature) to set the cleaning mode.
Option Cleaning mode Duration
P1 Light cleaning 1 h 30 min
P2 Normal cleaning 3 h
Step 3
- press to start the cleaning.
Step 4 After cleaning, turn the knob for the heating functions to the off position.
During the cleaning the oven lamp is off. The oven door stays locked. When the oven
is cold, the door unlocks.
ENGLISH 31
To Next Page
Loading...
