AEG BSS 4828 - Page 33

English
33
NOTE:
• Dependingonthedevicemanufacturer,youneedto
perform the registration (PAIRING) again to connect the
devices.
• Incaseofproblemsduringrepairingofaplayback
device, deactivate the WiFi-/ and mobile data function
in your playback device.
• TheBluetoothcompatibilitycannotbeensuredfor
devices (e.g. mobile phones) getting released in the
future.
• Toensureanoptimalconnection,makesurethatthe
battery of your player is completely charged.
• Someofthemobilephonebrandshaveanenergy-sav-
ing mode. Deactivate the energy-saving mode as it can
otherwise result in problems during the data transfer
through Bluetooth.
• Tobeabletotransferaudiodata,Bluetoothneedsto
stay activated in your player Observe the operation
manual of your player.
• Ifamobilephoneonwhichyouareplayingmusic
receives a call, the music will be interrupted. Sound
will however not be transmitted via the speakers. After
you have terminated the phone call, the devices will be
connected to each other again. You may have to restart
playback.
AUX IN 1 & AUX IN (white/cyan)
Doyouwanttolistentomusicfromanexternalaudiosource,
such as a PC or CD player, on these speakers?
1. Use the correct input cable (not included) and connect it
from the audio source to one of the AUX inputs.
NOTE:
Does your audio source have a controlled audio out-
put? Then adjust it to a moderate volume.
2. Start the track on your audio source.
3. Use the SOURCE button to select the correct AUX input
4. Adjust the volume with the VOL + or VOL - buttons.
USB Function (yellow)
NOTE:
This system has been developed according to state of the
art USB technology.
In spite of this, we cannot guarantee full compatibility, since
the number of different USB storage media and the differ-
ent software programs is too great.
Therefore, in rare cases there may be problems with USB
storage media playback.
This is not a malfunction of the system.
CAUTION: Avoid interference from other devices!
• Wheneverpossible,alwaysconnectaUSBstorage
device directly!
• Ifthisisnotpossible,useinputcableswhichareshorter
than 100 cm!
1. Press the SOURCE button repeatedly until the indicator
lamp lights up yellow.
2. Connect a USB storage device.
3. Playback begins after a few seconds.
For operation, please refer to the section entitled “Description
of the controls”.
NOTE:
The USB port is also suitable for charging.
CAUTION:
Before you remove the USB storage device, switch to
another operating mode! To do so, press the SOURCE
button.
Description of the controls
You can pause and continue music playback. Press again to
continue playback.
TUNE -
Press1x= Restartofthesongfromthebeginning.
Press2x= Skiptotheprevioussong.
Press3x= Skiptothesongbeforetheprevioussong.
TUNE +
Presstoskiptothenextsongandthefollowingsongs.
Cleaning
CAUTION:
Do not submerge the device in water.
• Beforecleaningdisconnectfrommainspowersupply.
• Cleanthedevicewithasoftdampclothwithoutdeter-
gents.
Troubleshooting
Fault Cause Solution
Unit cannot be
operated.
Unit crashes
and “hangs”.
Disconnect from the
mains for around 5 sec-
onds. Then switch the unit
on again.