AEG CaFamosa - What to do if...

g
27
0 Empty the spent coffee container and
the drip catcher, and refit them. The
“Spent Coffee“ indicator (Figure
1/O) goes out. All 4 green indicators
flash, the “Descale“ indicator (Fig-
ure 1/M) illuminates.
0 Place a sufficiently large container
under the swivelling nozzle (Figure 23).
0 Start the descaling program by turning
the selector dial (Figure 1/E) anticlock-
wise to the stop (Figure 16/A). The
“Descale“ indicator (Figure 2/M)
flashes.
Descaler is now pumped through the
system at short intervals.
0 If during the cleaning program the
“Spent Coffee“ indicator (Figure 2/O)
lights up, empty the drip catcher and
then replace it. All 4 green indicators
flash, the “Descale“ indicator illu-
minates (Figure 1/M).
0 Turn the selector dial (Figure 1/E)
clockwise back to the 0-position (Fig-
ure 16/B). The descaling program is
continued. If the “Spent Coffee“
indicator (Figure 2/O) lights up, empty
the drip catcher and then replace it. Do
not fill the water tank until the
"Water Tank" indicator (Figure 2/N)
illuminates.
After a period of time, the “Flush“
indicator (Figure 2/J) flashes while
the “Descale“ (Figure 2/M),
“Water Tank“ (Figure 2/N) and
“Spent Coffee“ indicators (Figure 2/O)
illuminate.
0 Now fill the water tank with fresh
water and refit it to the appliance.
0 Empty the drip catcher and refit. All 4
green indicators flash, the “Des-
cale“ indicator (Figure 1/M) illuminates.
0 Place a sufficiently large container
under the swivelling nozzle (Figure 23)
and turn the selector dial (Figure 1/E)
anticlockwise to the stop (Figure16/A).
The indicators “Flush“ (Figure 2/J)
and “Descale“ (Figure 2/M) flash.
After a certain amount of time, the
“Flush“ indicator (Figure 2/J)
flashes while the “Descale“ (Figure
2/M) and “Spent Coffee“ (Figure
2/O) indicators illuminate.
0 Empty the drip catcher and refit. Turn
the selector dial (Figure 1/E) clockwise
back to the 0-position (Figure 16/B).
The indicators “Flush“ (Figure 2/J)
and “Descale“ (Figure 2/M) flash. If
the “Spent Coffee“ indicator (Fig-
ure 2/O) lights up, empty the drip
catcher and then replace it. The descal-
ing program is continued.
After a certain amount of time, the
“Flush“ indicator (Figure 2/J)
flashes while the “Descale“ (Figure
2/M) and “Spent Coffee“ (Figure
2/O) indicators illuminate.
Empty the drip catcher and then
replace it. The “Flush“ indicator
(Figure 2/J) illuminates.
0 Flush the appliance by pressing the
“Flush“ button (Figure 2/K).
0 Rinse out the water tank.
The appliance is now ready for use
again when the “1 Normal Cup“
indicator (Figure 2/D) illuminates.
10. What to do if ...
• no coffee runs out of the spouts:
– Check that the water tank is cor-
rectly seated!
– Fill the water tank!
– Check the correct seating of the drip
catcher!
• coffee only drips out of the spouts:
– Set the grinding texture to a coarser
setting.
• too little froth is produced on the milk
during frothing?
– Always use cool, fresh (low fat) milk!
– Use a suitable container (e.g. jug)!
– Also cool the container if necessary!
– Dismantle the swivelling nozzle and
clean!