4.1 Initial Cleaning
Remove all accessories and removable
shelf supports from the oven.
Refer to "Care and cleaning" chapter.
Clean the oven and the accessories
before the first use.
Put the accessories and the removable
shelf supports back to their initial
position.
4.2 Setting the time
You must set the time before you
operate the oven.
The
flashes when you connect the
appliance to the electrical supply, when
there was a power cut or when the timer
is not set.
Press the
or to set the correct
time.
After approximately five seconds, the
flashing stops and the display shows the
time of day you set.
4.3 Changing the time
You cannot change the time
of day if the Duration or
End function operates.
Press again and again until the
indicator for the Time of Day function
flashes.
To set a new time, refer to "Setting the
time".
4.4 Retractable knobs
To use the appliance press the knob. The
knob comes out.
4.5 Preheating
Preheat the empty oven before first use.
1. Set the function
.Set the maximum
temperature.
2. Let the oven operate for 1 hour.
3. Set the function
. Set the
maximum temperature.
4. Let the oven operate for 15 minutes.
5.
Set the function
. Set the
maximum temperature.
6. Let the oven operate for 15 minutes.
7. Turn off the oven and let it cool
down.
Accessories can become hotter than
usual. The oven can emit an odour and
smoke. Make sure that the airflow in the
room is sufficient.
5.
HOB - DAILY USE
WARNING!
Refer to Safety chapters.
5.1 Heat setting
Symbols Function
Off position
Double zone
Keep warm
1 - 9 Heat settings
Use the residual heat to
decrease energy
consumption. Deactivate the
cooking zone approximately
5 - 10 minutes before the
cooking process is
completed.
Turn the knob for the selected cooking
zone to a necessary heat setting.
To complete the cooking process, turn
the knob to the off position.
5.2 Activating and
deactivating the outer rings
You can adjust the surface you cook to
the dimension of the cookware.
ENGLISH
9
To Next Page
Loading...
Need help?
General
