English
30
Instructions
Unpacking
• Remove any protective foils and stickers from the
soleplate.
• Please unwind the lead completely.
• Use the cable holder to guide the connecting hose
(2).
Electrical connection
• Make sure that the iron voltage (see name plate) and
the line voltage match.
• The mains plug should only be inserted into a cor-
rectly installed 230 V ~ 50 Hz socket with earthing
contact.
Connected Wattage
• The station has a total maximum wattage of 2100 W.
With this connected load a separate supply line
protected by a 16 A household circuit breaker is
recommended.
CAUTION: OVERLOAD!
• If you use extension leads, these should have a
cable cross-section of at least 1.5 mm
2
.
• Do not use any multiple sockets, as this device is
too powerful.
Temperature Control on the Iron
The symbols on the control correspond to the following
settings:
• (Synthetics, silk) low temperature
• • (Wool ) medium temperature
• • • (Cotton, linen) highest temperature
Water Tank (8)
• In order to ll the water tank, push the lock (9) open
and use the funnel supplied.
• The tank volume is 1.4 litres.
Water
Please use only distilled water. Do not ll battery water,
water from the clothes dryer and water containing
additives (such as starch, perfume, softener or other
chemicals) into the water reservoir. This could damage
the iron due to residues forming in the steam chamber.
These residues may cause impurities to the fabric when
dropping out of the holes in the soleplate.
Operation
Before Initial Use
• Clean the ironing base with a slightly damp cloth.
• In order to remove all residues before initial use,
please pass the iron a few times over an old clean
cloth.
Ironing without steam
쫵 NOTE:
• Sort out the garments according to their ironing
temperatures.
• Always set the temperature control to „0“ before
connecting the appliance to a power point, or
before disconnecting it.
• Place the iron on the rest (7).
• Only connect the machine to a properly installed
safety socket, 230 V/50 Hz.
• Set the temperature on the temperature control (1).
If you have sensitive items to iron, please begin with
the lowest temperature.
쫵 NOTE:
The control lamp (11) on the iron shows that it is
heating up. As soon as the control lamp goes o the
operating temperature has been reached. Now you can
start ironing.
• Always turn the temperature control to „0“ after use
and remove the mains plug (the control lamp in the
handle goes o ).
Steam Ironing
WARNING:
The iron expels a large quantity of hot steam. Danger
of burns.
CAUTION:
When using the steam iron please ensure that the wa-
ter tank is always lled to the required level. Operating
the device without water will damage it.
05-DBS 5533.indd 3005-DBS 5533.indd 30 09.02.2009 11:36:57 Uhr09.02.2009 11:36:57 Uhr
To Next Page
Loading...
Need help?
General
