Why is my AEG DBS2300 not producing steam?
If your AEG Iron is not producing steam, it could be due to a small amount of water in the water tank. Fill the water tank to the MAX level. Also, your iron may have air in the water tank. After the steam lamp lights, press the steam button for more than one minute to air the system and then get steam.
What to do if steam escapes from under my AEG Iron?
If steam or water escapes under the appliance of your AEG Iron, the station is faulty. Stop using the station and contact an Approved service centre.
Why does my AEG DBS2300 Iron leave brown streaks?
If brown streaks come through the holes in the soleplate of your AEG Iron and stain the linen, it could be due to using chemical descaling agents or additives in the water. Never add these products to the water tank or boiler. Another cause could be fabric fibres accumulating in the soleplate holes and burning. To resolve this, clean the soleplate with a non-metallic sponge.
Why is my AEG Iron leaking water?
If water is running out of the holes in the soleplate of your AEG Iron, it could be due to a few reasons. Firstly, water may have condensed in the pipes because you're using steam for the first time or haven't used it for a while. Press the steam control button away from your ironing board until the iron produces steam. Secondly, the soleplate may not be hot enough, so increase the heat. If the thermostat is faulty and the iron isn't hot enough, contact an Approved Service Centre.
What to do if my AEG Iron soleplate is dirty?
If the soleplate of your AEG Iron is dirty or brown and may stain the linen, it could be because you are ironing at too high a temperature. Refer to the temperature control setting recommendations. It may also be because your linen isn't rinsed sufficiently, or you've ironed a new garment before washing it. Ensure linen is rinsed thoroughly. If you are using starch, always spray it on the reverse side of the fabric to be ironed.
Lists and labels all parts of the steam station.
Essential safety precautions for operating the appliance.
Guide to ironing different fabrics with temperature settings.
Unpacking, tank removal, and filling.
Connecting, temperature setting, and steam activation.
How to connect, power on, and use steam.
Cooling down, cord winding, and storage.
Instructions for the automatic cleaning process.
Steps to replace the anti-lime cartridge.
Addresses issues like water leaks, stains, and no steam.
Guidance on disposing of packaging and the old appliance.
General| Iron power | - W |
|---|---|
| Product color | Red, White |
| Soleplate type | Stainless Steel soleplate |
| Variable steam | Yes |
| Automatic anti-calc | - |
| Water tank capacity | 0.9 L |
| Maximum steam pressure | - bar |
| Steam boost performance | - g/min |
| Continuous steam performance | 75 g/min |
| Cord length | 1.8 m |
| Connected load | 2300 W |
Weight and Dimensions| Weight | 3900 g |
|---|
To Next Page
