5
ENGLISH
after terminating cooking.
The control switches are located on the
hood’s front panel:
A OFF – ON push button
Press once or more to obtain the
function desired:
ON: the hood switches on to the last
speed selected.
OFF: all the functions are switched off
except the illumination.
B
Press this push button once or more
to select the most suitable extraction
C The display shows the extraction power
selected, signalling the saturation of the
D Intensive speed on/off. The Intensive
speed runs for 5 minutes:
If the hood is on when the Intensive
speed is activated, the hood reverts to
previous speed after 5 minutes.
If the hood is off when the Intensive
speed is activated, the hood will be
turned off after 5 minutes.
To interrupt the Intensive speed, press
button A or B .
E Light ON/OFF
Should the hood or the controls fail to
operate: disconnect the power supply for at
least 5 seconds, then turn the hood back
on again.
indicator
indicates when it is necessary to clean the
hood is used in the recirculation version
On delivery, the hood is not supplied with
will be disabled.
If the hood is to be used with a charcoal
indicator light must be enabled as follows:
Set the hood in “OFF”.
Pressing keys B and D simultaneously
for three seconds, LED F lights up and
indicate setting taking place.
push buttons B and D simultaneously for
3 seconds. LED F lights up and begins to
the 2nd speed led. After 1 second, only
indicate setting taking place.
Always comply with the maintenance
cleaned or replaced.
Resetting the saturation indicator
button A for 3 seconds until the 1st speed
The F LED also turns off.
6. LIGHTING
The hood is equipped with a lighting system
based on LED technology.
The LEDs guarantee an optimum lighting,
a duration up to 10 times as long as the
traditional lamps and allow to save 90%
electrical energy.
Caution! Do not look directly into the
LED light.
To replace lights, contact authorised spare
part center.
To Next Page
Loading...
