AEG Eclipse 15 - Switching Handset On;Off; Lock;Unlock Keypad

UK
8.4 Adjust Earpiece Volume
There are 5 levels of earpiece volume on your Handset.
tDuring a call, press
to select from “VOLUME 1” to “VOLUME 5”.
>The current setting is shown.
>When you end the call, the setting will remain at the last selected level.
8.5 Adjust Speaker Volume
There are 5 levels of speaker volume.
tDuring a handsfree call, press
to select from “VOLUME 1” to “VOLUME 5”.
>The current setting is shown.
>When you end the call, the setting will remain at the last selected level.
8.6 Mute/Unmute the Microphone
tWhen the microphone is muted, the handset displays “MUTE ON” and your caller cannot hear you.
tDuring a call, press
to turn on/off the microphone.
8.7 Paging
The paging feature enables you to locate a missing handset if the handset is in range and contains
charged batteries.
tPress the
key under the base unit.
>All the registered handsets that are in range will start to ring.
You can stop the paging by pressing any key on a handset or the
key under the base unit again.
8.8 Switching the Handset On/Off
Press and hold
on your Handset for more than 2 seconds to switch the handset on or off in standby
mode.
>When first turned on, the display shows “SEARCHING…” until the handset finds the base.
Note: You can switch the handset off to save battery life, if the handset is not on the base.
IMPORTANT:
When the handset is “OFF”, it cannot be used for making calls including emergency calls. It will not ring
when there is an incoming call.
To answer a call, you will need to switch it back on and it may take some time for the handset to re-
establish a radio link with the base unit.
8.9 To Lock/Unlock the Keypad
You can lock the keypad to avoid making calls or pressing the keys accidentally.
tIn standby mode, press and hold
for 2 seconds to lock the keypad.
>The handset displays “KEYS LOCKED”.
tTo turn the keypad lock off, press and hold
again.
Note: Incoming calls can still be answered even if the keypad is locked.