EasyManua.ls Logo

AEG FFB73717PM - Before First Use

AEG FFB73717PM
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
= AirDry is activated.
2. Press Delay to change the setting.
3. Press the on/off button to confirm the
setting.
7.5 Factory reset
Factory reset restores the factory
defaults. Before the reset, make sure the
appliance is in user mode.
Press and hold Start and Option for 5
seconds.
The displays shows _ _ _ for about 5
seconds.
The appliance returns to programme
selection mode.
Factory reset does not reset
the cycle counter.
7.6 Cycle counter
You can view the number of completed
dishwashing cycles in the cycle counter.
1. Press the on/off button to activate the
dishwasher. Make sure that the
appliance is in programme selection
mode.
2. Press and hold Start and Option for
5 seconds.
The displays shows uC and then the
number of cycles.
Press any button to exit the cycle
counter.
After reaching 65535, the
cycle counter restarts.
8. BEFORE FIRST USE
1. Make sure that the current level of
the water softener agrees with the
hardness of the water supply. If
not, adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
detergent and do not put dishes in
the baskets.
After starting the programme, the
appliance recharges the resin in the
water softener for up to 5 minutes. The
washing phase starts only after this
procedure is complete. The procedure is
repeated periodically.
8.1 The salt container
CAUTION!
Use rough salt designed for
dishwashers only. Fine salt
increases the risk of
corrosion.
The salt is used to recharge the resin in
the water softener and to assure good
washing results in daily use.
How to fill the salt container
1. Turn the cap of the salt container
counterclockwise and remove it.
2. Put 1 litre of water in the salt
container (only for the first time).
3. Fill the salt container with dishwasher
salt (until it is full).
4. Carefully shake the funnel by its
handle to get the last granules inside.
5. Remove the salt around the opening
of the salt container.
www.aeg.com14

Related product manuals