CLEANING AND MAINTENANCE
Cleaning is the only maintenance
action that is required normally.
WARNING!
Cleaning must be done with the
Warming Drawer disconnected from
the electrical power supply. Remove
the plug from the power socket or
disconnect the Warming Drawer power
supply circuit.
Do not use aggressive or abrasive
cleaning products, abrasive sponges
or pointed objects since stains or
abrasion marks may appear.
Do not use high pressure or steam jet
cleaning appliances.
APPLIANCE FRONT AND
CONTROL PANEL
The Warming Drawer can be cleaned
using just a damp cloth. If it is very
dirty, add a few drops of washing-up
liquid to the washing water.
Wipe the surfaces dry using a dry
cloth.
INTERIOR OF THE WARMING
DRAWER
Clean the inside of the Warming
Drawer regularly using a damp cloth. If
it is very dirty add a few drops of
washing-up liquid to the washing
water.
Wipe the surfaces dry using a dry
cloth.
Avoid water entering through the air
circulation opening.
Only use the Warming Drawer again
when it is completely dry.
ANTI-SLIP MAT
The non-slip surface mat can be
removed to facilitate cleaning of the
drawer.
The mat can be cleaned by hand using
hot water with a few drops of washing-
up liquid. Dry thoroughly.
The non-slip mat should only be
replaced when it is completely dry.
To Next Page
