AEG L6FBK841B User Manual

12.6 Starting a programme
Touch the Start/Pause button to start the
programme.
The related indicator stops flashing and
stays on.
The programme starts, the door is
locked. The display shows the indicator
.
The drain pump can operate
shortly before the appliance
fills water.
12.7 Starting a programme
with the delay start
Touch the Start/Pause button.
The appliance starts the countdown of
the delay start.
When the countdown is completed, the
programme starts.
The PROSENSE adapts
starts at the end of the
countdown.
Cancelling the delay start
after the countdown has
started
To cancel the delay start:
1. Touch the Start/Pause button to
pause the appliance. The related
indicator flashes.
2. Touch the Delay Start button
repeatedly until the display shows .
3. Touch the Start/Pause button again
to start the programme immediately.
Changing the delay start after
the countdown has started
To change the delay start:
1. Touch the Start/Pause button to
pause the appliance. The related
indicator flashes.
2. Touch the Delay Start button
repeatedly until the display shows the
desired delay time.
3. Touch the Start/Pause button again
to start the new countdown.
12.8 The ProSense load
detection
The programme duration in
the display is referred to a
medium/high load.
1. The appliance detects the load in the
first 30 seconds: the indicator and
the time dots flash, the drum rotates
shortly.
2. At the end of the load detection, the
indicator goes off and the time
dots stop flashing. The programme
duration will be adjusted accordingly
and could increase or decrease. After
further 30 seconds, the water filling
starts.
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Start/Pause button to start the
programme again. The ProSense phase
can be repeated up to three times (see
point 1).
Important! If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
About 20 minutes after the
programme start, the
programme duration could
be adjusted again depending
on the capacity of water
absorption of the fabrics.
The ProSense detection is
carried out with complete
washing programmes only
(no skipping phase
selected).
The ProSense is not
available with some
programmes, such as Wool/
Silk, programmes with short
cycles and without washing
phase.
ENGLISH 23

AEG L6FBK841B Specifications

General

Door hinge	Left
Water fill	Cold
Cord length	1.8 m
Control type	Buttons, Rotary
Display type	LED
Door opening	Side opening
Loading type	Front-load
Drum material	Stainless steel
Product color	White
Built-in display	Yes
Country of origin	Poland
Inlet hose length	1.3 m
Illumination color	Red
Outlet hose length	1.45 m
Appliance placement	Freestanding
Self-cleaning	-
Drum capacity	8 kg
Maximum spin speed	1400 RPM
Noise level (wash)	75 dB
Number of washing programs	14
Current	13 A
Connected load	1900 W
AC input voltage	230 - 240 V
AC input frequency	50 Hz
Water consumption per cycle	43 L
Package depth	635 mm
Package width	640 mm
Package height	900 mm
Package weight	71000 g
Intrastat code	84501190

Weight and Dimensions

Depth	547 mm
Width	596 mm
Height	847 mm
Weight	69500 g