The Extra Rinse option. The indicator appears above the when
a extra rinse is set .
Spinning and draining phase indicator. It flashes during spin and drain
phase.
Child safety lock indicator.
Temperature indicator. The indicator appears when a cold wash is
set.
Spin speed indicator.
No spin speed indicator. Spin phase is off.
Rinse hold indicator.
Extra silent indicator.
Time saving indicator.
8. DIAL AND BUTTONS
8.1 On/Off
Pressing this button for a few seconds
allows to activate or deactivate the
appliance. Two different tunes sound
while switching the appliance on or off.
As the Stand-by function automatically
deactivates the appliance to decrease
the energy consumption in a few cases,
you may need to activate the appliance
again.
For more details, refer to Stand-by
paragraph in Daily Use chapter.
8.2 Introduction
The options/functions are
not selectable with all
washing programmes.
Check the compatibility
between options/functions
and washing programmes in
the "Programme Chart". An
option/function can exclude
another one, in this case the
appliance doesn't allow you
to set the incompatible
options/functions together.
Make sure the screen and
touch buttons are always
clean and dry.
8.3 Temp.ºC
When you select a washing programme,
the appliance automatically proposes a
default temperature.
Touch this button repeatedly until the
desired temperature value appears on
the display.
When the display shows the indicators
and , the appliance does not heat
the water.
www.aeg.com14
To Next Page
Loading...
Need help?
General
