EasyManua.ls Logo

AEG L7WE74634BI - User Manual

AEG L7WE74634BI
56 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
aeg.com/register
L7WE74634BI
EN User Manual | Washer Dryer
aeg.com\register

Table of Contents

Questions and Answers

  • H
    Holly WallaceAug 13, 2025
    How to fix AEG L7WE74634BI that does not fill with water properly?
    • C
      Chelsey CoxAug 13, 2025
      If your AEG Washer/Dryer isn't filling with water properly, start by ensuring the water tap is fully open. Also, check that the water supply pressure isn't too low – contact your local water authority for information on this. Make sure the water tap isn't clogged. Inspect the inlet hose for any kinks, damages, or bends, and verify that it's correctly connected. Finally, check the inlet hose filter and the valve filter for clogs, cleaning them if necessary.
  • S
    Steven CoxAug 18, 2025
    Why AEG L7WE74634BI Washer/Dryer programme does not start?
    • P
      Patrick BakerAug 18, 2025
      If your AEG Washer/Dryer isn't starting, make sure the mains plug is properly connected to the socket. Ensure the appliance door is fully closed. Check the fuse box for any damaged fuses. Verify that you've touched the Start/Pause button. If the delay start function is set, either cancel the setting or wait for the countdown to finish. Deactivate the Child Lock function if it's active. Also, check the position of the knob to ensure it's on the selected program. Finally, make sure the drain hose is correctly positioned, as a hose positioned too low can prevent the machine from starting.
  • J
    Justin JonesAug 23, 2025
    How to stop AEG L7WE74634BI Washer/Dryer from making unusual noise and vibrating?
    • W
      wgregoryAug 25, 2025
      If your AEG Washer/Dryer is making unusual noises and vibrating, ensure the appliance is correctly leveled. Also, confirm that all packaging and transit bolts have been removed. If the load is too small, add more laundry to the drum. For balance issues, manually adjust the items in the tub and restart the spin phase.
  • A
    Angelica BurnsAug 28, 2025
    What to do if there is too much foam in AEG L7WE74634BI during washing?
    • D
      djonesAug 28, 2025
      If there's too much foam in the drum of your AEG Washer/Dryer during the washing cycle, try adjusting the detergent. You might need to increase the detergent quantity or switch to a different detergent. Alternatively, reduce the quantity of detergent, tablets, or single-dose detergents you're using. Ensure you're setting the correct temperature for your wash. Also, check that the detergent dispenser flap is in the correct position: UP for powder detergent and DOWN for liquid detergent. Lastly, make sure you're using the detergent dispenser according to the instructions in the user manual.
  • I
    Isaiah WilsonSep 3, 2025
    What causes AEG L7WE74634BI Washer/Dryer to leave laundry full of different colours fluff?
    • L
      Lisa OrtegaSep 3, 2025
      If your laundry is full of different colored fluff after using the AEG Washer/Dryer, it might be because the fabrics washed in the previous cycle released fluff of a different color. The drying phase can help eliminate some of this fluff. You can also clean the clothes with a fluff remover.
  • C
    cwrightNov 8, 2025
    What to do if my AEG L7WE74634BI Washer/Dryer does not drain the water?
    • M
      mooredarrellNov 8, 2025
      If your AEG Washer/Dryer isn't draining water, several factors could be at play. First, ensure the door is completely closed. A faulty door closure can prevent draining. If the issue persists, and an alarm code appears again, it indicates an internal communication problem, requiring you to contact an authorized service center. Unstable mains supply can also cause draining issues, so wait until the power stabilizes. The anti-flood device might be activated; in this case, disconnect the appliance, close the water tap, and contact an authorized service center. Check for clogs in the sink spigot or kinks in the drain hose. Clean the drain filter if necessary, and ensure the drain hose is correctly connected. If you've set a program without a drain phase or one that ends with water in the tub, ...

AEG L7WE74634BI Specifications

General IconGeneral
Appliance placementBuilt-in
Loading typeFront-load
Product colourWhite
Built-in displayYes
Control typeElectronic
Door colourWhite
Washing capacity7 kg
Drying capacity4 kg
Maximum spin speed1400 RPM
Spin-drying classB
Washing classA
Drying classB
Water consumption washing per cycle45 L
Width60 cm
Depth55 cm
Spin Speed1400 RPM
Energy Efficiency ClassA

Related product manuals