5. When the bowl is full of water, close
the drainage duct back and empty
the container.
6. Repeat the steps 4 and 5 until the
water stops flowing out.
7. Close the drainage duct and turn the
filter anti-clockwise to remove it.
8. If it is necessary, remove fluff and
objects from the filter recess.
9. Make sure that the impeller of the
pump can rotate. If it does not
rotate, contact the Authorised
Service Centre.
10. Clean the filter under the water tap.
11. Put the filter back into the special
guides by turning it clockwise. Make
sure that you tighten the filter
correctly to prevent leakages.
12. Close the pump access.
When you drain the water with the
emergency drain procedure, you must
activate the drain system again:
a. Put 2 litres of water in the main
wash compartment of the
detergent dispenser.
b. Start the programme to drain the
water.
www.aeg.com
44
To Next Page
Loading...
