Problem Possible solution
Too much foam in the
drum during the wash‐
ing cycle.
• Reduce the quantity of detergent.
After the washing cy‐
cle, there are some
detergent residues in
the dispenser drawer.
• Make sure that the flap is in the correct position (UP for pow‐
der detergent - DOWN for liquid detergent).
• Make sure you have used the detergent dispenser according
the indications given in this user manual.
After the check, activate the appliance. The programme continues
from the point of interruption.
If the problem occurs again, contact the Authorised Service Centre.
The necessary data for the service centre are on the rating plate.
16. CONSUMPTION VALUES
16.1 Introduction
See the web link www.theenergylabel.eu for detailed information about
Energy Label.
The QR code on the energy label supplied with the appliance provides a
web link to the information related to the performance of the appliance in
the EU EPREL database. Keep the energy label for reference together
with the user manual and all other documents provided with this
appliance.
It is also possible to find the same information in EPREL using the link
https://eprel.ec.europa.eu and the model name and product number that
you find on the rating plate of the appliance. Refer to 'Product description'
chapter for the position of the rating plate.
16.2 Legend
kg Laundry load. hh:mm Programme duration.
kWh Energy consumption. °C Temperature in the laundry.
Litres Water consumption. rpm Spin speed.
% Remaining moisture at the end of spinning phase. The higher is the spin speed,
the higher is the noise and the lower is the remaining moisture.
Values and programme duration may differ depending on different
conditions (e.g. room temperature, water temperature and pressure, load
size and type of laundry, supply voltage) and also if you change the
default setting of a programme.
ENGLISH 35
To Next Page
Loading...
