hundreds) for 2 seconds and 76 (tens and
units).
If the procedure does not work (due to
timeout, wrong programme dial position
or wrong keys combination), switch the
appliance off and repeat sequence from
the beginning.
10.5 Factory Reset
This function allows to restore the factory
default options. To activate this option follow
steps below:
1. Switch the appliance on by pressing
On/Off button.
2. Turn the programme knob to any
programme.
3. Press and hold the Centrif. and Fácil
Plancha/Engomar buttons for some
seconds (within 10 seconds after the
switching on. After these 10 seconds, the
key combination activates and
deactivates the acoustic signals).
4. The display will show for about 5
seconds.
If the procedure does not work (due to
timeout, wrong programme dial position
or wrong keys combination), switch the
appliance off and repeat sequence from
the beginning.
11. BEFORE FIRST USE
1. Make sure that all transit bolts have been
removed from the appliance.
2. Make sure that the electrical power is
available and the water tap is open.
3. Pour a small quantity of detergent into the
compartment marked .
4. Set and start a programme for cotton at
the highest temperature without any
laundry in the drum.
This removes all possible dirt from the drum
and the tub.
12. DAILY USE
WARNING!
Refer to Safety chapters.
12.1 Activating the appliance
1. Connect the mains plug to the mains
socket.
2. Open the water tap.
3. Press the On/Off button for a few
seconds to activate the appliance.
A short tune sounds. The appliance
automatically proposes a default programme.
The relevant indicator illuminates.
The display shows the maximum load, the
default temperature, the default spin speed,
the indicators of the phases making up the
programme and the cycle duration.
12.2 Loading the laundry
1. Open the appliance door.
2. Shake the items before you put them in
the appliance.
3. Put the laundry in the drum, one item at a
time.
Make sure not to put too much laundry in the
drum.
4. Close the door firmly.
22 ENGLISH
To Next Page
Loading...
