12. Close the pump cover.
14.10 Cleaning the inlet hose and
the valve filter
It is recommended to clean both the filters of
the inlet hose and valve occasionally to
remove any deposit, collected over the time:
1. Remove the inlet hose from the tap and
clean the filter.
2. Remove the inlet hose from the appliance
by loosening the ring nut.
3. Clean the valve filter on the back of the
appliance with a toothbrush.
4. When you reconnect the hose to the back
of the appliance, turn it left or right (not in
vertical position) depending on the
position of your water tap.
14.11 Emergency drain
If the appliance cannot drain the water, carry
out the same procedure, described in
'Cleaning the drain pump' paragraph. If
necessary, clean the pump.
34 ENGLISH
To Next Page
