10. BEFORE FIRST USE
During installation or before first use you
may observe some water in the
appliance. This is residual water left in
the appliance after a full functional test in
the factory to ensure the appliance is
delivered to customers in perfect working
order and is no cause for concern.
1. Connect the mains plug to the mains
socket.
2. Open the water tap.
3. Put 2 litre of water in the detergent
compartment for washing phase.
This activates the drain system.
4. Put a small quantity of detergent in the
compartment for washing phase.
5. Set and start a programme for cotton at
the highest temperature without laundry.
This removes all possible dirt from the drum
and the tub.
11. DAILY USE
WARNING!
Refer to Safety chapters.
11.1 Activating the appliance
1. Connect the mains plug to the mains
socket.
2. Open the water tap.
3. Press button Zap./Vyp. to activate the
appliance.
A short tune sounds.
11.2 Loading the laundry
1. Open the appliance lid.
2. Push the button A.
The drum opens automatically.
3. Put the laundry in the drum, one item at a
time.
4. Shake the items before you put them in
the appliance.
Make sure not to put too much laundry in the
drum.
5. Close the drum and the lid.
CAUTION!
Before you close the lid of your
appliance, make sure that you close the
drum correctly.
11.3 Detergent compartments.
Using detergent and additives
1. Measure out specified detergents for
washing machine the detergent and the fabric
conditioner.
2. Put the detergent and the fabric conditioner
into the proper compartments.
Always obey the instructions that you find
on the packaging of the detergent
products.
ENGLISH 21
To Next Page
Loading...
Need help?
General
