11.6 Starting a programme without
the delay start
Press button Start/Pauza to start the
programme.
The relevant indicator stops to flash and
stays on.
On the display the indicator of the phase is
operation starts to flash.
The programme starts, the lid is locked. The
display show the indicator .
The drain pump can operate for a short
time when the appliance fills water.
11.7 Cycle time recalculation
After approximately 15 minutes from the
start of the programme:
• The appliance adjusts automatically
the cycle time to the laundry you have
put in the drum to have perfect
washing results in the minimum
necessary time.
• The display shows the new time
value.
11.8 Starting a programme with the
delay start
1. Press button Odložený start again and
again until the display shows the number
of minutes or hours of delay.
The related indicator comes on.
2. Press button Start/Pauza.
The appliance starts the countdown of the
delay start.
When the countdown is completed, the
programme starts automatically.
Before you press button Start/Pauza to
start the appliance, you can cancel or
change the set of the delay start.
11.9 Cancelling the delay start
To cancel the delay start:
1. Press button Start/Pauza to set the
appliance to pause.
The related indicator flashes.
2. Press button Odložený start repeatedly
until the display shows .
3. Press button Start/Pauza again to start
the programme immediately.
11.10 Interrupting a programme and
changing a option
You can change only some options before
they operate.
1. Press button Start/Pauza.
The related indicator flashes.
2. Change the option set.
3. Press the button Start/Pauza again.
The programme continues.
11.11 Cancelling a running
programme
1. Press button Zap./Vyp. to cancel the
programme and to deactivate the
appliance.
2. Press button Zap./Vyp. again to activate
the appliance.
Now, you can set a new washing programme.
Before starting the new programme the
appliance could drain the water. In this
case, make sure that the detergent is still
in the detergent compartment, if not fill
the detergent again.
11.12 The ProSense load detection
The programme duration in the display is
referred to a medium/high load.
After touching the Start/Pauza button, the
maximum declared load indicator goes off,
the indicator flashes, the ProSense starts
the laundry load detection:
1. The appliance detects the load in the first
30 seconds: the indicator and the time
dots flash, the drum rotates shortly.
2. At the end of the load detection, the
indicator goes off and the time dots
stop flashing. The programme duration
will be adjusted accordingly and could
ENGLISH 23
To Next Page
Loading...
Need help?
General
