13.5 Maintenance wash
With the low temperature programmes it is
possible that some detergent stays in the
drum. Perform a maintenance wash regularly.
To do this:
• Remove all laundry from the drum.
• Select the cotton programme with the
highest temperature with a small quantity
of detergent.
13.6 Lid seal
Regularly examine the seal and remove all
objects from the inner part. Clean it when
needed, using ammonia cream cleanser
agent without scratching the seal surface.
Always obey the instructions that you find
on the packaging of the product.
13.7 Cleaning the drum
Regularly examine the drum to prevent rust
particles.
For a complete cleaning:
1. Clean the drum with special products for
stainless steel.
Always follow the instructions that you
find on the packaging of the product.
2. Run a short cotton programme at high
temperature or use if is available
programme Čištění pračky. Add a small
quantity of powder detergent into empty
drum, in order to rinse out any left
residues.
13.8 Cleaning the detergent dispenser
13.9 Cleaning the drain filter
Regularly check the drain pump filter and
make sure that it is clean.
Clean the drain pump if:
• The appliance does not drain the water.
• The drum does not turn.
• The appliance makes an unusual noise
because of the blockage of the drain
pump.
• The display shows the alarm code
WARNING!
• Disconnect the mains plug from the
mains socket.
• Do not clean the pump if the water in
the appliance is hot. Wait until the
water cools down .
• Do not remove the filter while the
appliance operates.
• Unscrew the filter slowly and gently
until the water stops flowing out. After
water has been drained, filter can be
unscrewed fully.
Always keep a rag nearby to dry up any
water spillages when removing the filter.
28 ENGLISH
To Next Page
Loading...
