EasyManua.ls Logo

AEG LX6WG74634BI - User Manual

AEG LX6WG74634BI
56 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
aeg.com/register
LX6WG74634BI
EN User Manual | Washer Dryer
aeg.com\register

Table of Contents

Questions and Answers

  • A
    Alex StoneAug 11, 2025
    What to do if my AEG Washer/Dryer does not drain the water?
    • C
      Christina RobinsonAug 12, 2025
      If your AEG Washer/Dryer isn't draining water, several factors could be at play. First, ensure the door is completely closed. Other possible causes include an unstable mains supply (wait for it to stabilize), a clogged sink spigot, kinks or incorrect connections in the drain hose, or a clogged drain filter (clean if necessary). Also, the anti-flood device might be activated, in this case disconnect the appliance, close the water tap and contact an Authorised Service Centre. Make sure you have set the drain programme if you set a programme without drain phase or an option which ends with water in the tub. Finally, if the programme wasn't finished properly, try switching the appliance off and on again. If the alarm code appears again, contact the Authorised Service Centre.
  • C
    Christina HicksAug 19, 2025
    How to fix an AEG Washer/Dryer that does not fill with water properly?
    • D
      Daniel VillanuevaSep 12, 2025
      If your AEG Washer/Dryer isn't filling with water properly, there are several things to check: * Ensure the water tap is fully open. * Verify that the water supply pressure isn't too low (contact your local water authority for information). * Make sure the water tap isn't clogged. * Check the inlet hose for kinks, damages, or bends. * Confirm the water inlet hose is correctly connected. * Inspect the inlet hose filter and the valve filter for clogs, cleaning them if necessary.
  • M
    medinalaurenAug 26, 2025
    Why does my AEG Washer/Dryer programme not start?
    • K
      Karen ThomasAug 26, 2025
      If the AEG Washer/Dryer programme won't start, make sure the mains plug is correctly connected to the mains socket and that the appliance door is fully closed. Check the fuse box for any damaged fuses. Ensure you've touched the Start/Pause button. If the delay start is set, either cancel the setting or wait for the countdown to finish. Deactivate the Child Lock function if it's active. Also, verify the knob position corresponds to the selected programme. Finally, ensure the drain hose is in the correct position.
  • M
    Michelle JonesSep 3, 2025
    What to do if AEG LX6WG74634BI washing results are not satisfactory?
    • K
      Kayla CastilloSep 3, 2025
      If you're not getting satisfactory washing results with your AEG Washer/Dryer, consider the following: If there's too much foam in the drum during the wash, increase the detergent quantity or switch to a different detergent. If detergent residues remain in the dispenser drawer after washing, ensure you're using the detergent dispenser as instructed in the user manual. For stubborn stains, pretreat the laundry with special stain removal products before washing. Confirm that you've set the correct temperature and try decreasing the laundry load. If you are using too much detergent, reduce the quantity of detergent or the number of tablets or single-dose detergents.

AEG LX6WG74634BI Specifications

General IconGeneral
BrandAEG
ModelLX6WG74634BI
CategoryWasher/Dryer
LanguageEnglish

Related product manuals