AEG MCC4538E - Technical Characteristics; Installation Instructions

39
www.aeg.com
17.1. Substitution of light bulb
To substitute the light bulb, proceed as
follows:
1. Disconnect the oven from the
power supply. Take the plug out of
the socket or switch off the oven’s
power circuit.
2. Unscrew and remove the glass
light cover (1).
3. Remove the halogen light bulb (2).
Warning! The bulb may be very
hot.
4. Fit a new G4/12V/10-20W halogen
bulb. Warning! Do not touch the
light bulb surface directly with your
fingers because you may damage
the bulb. Follow the lamp
manufacturer’s instructions.
5. Screw the glass light cover into
place (1).
6. Connect the oven again to the
power supply.
18. TECHNICAL CHARACTERISTICS
18.1. Specifications
AC Voltage
(see rating plate)
Power required
3400 W
Grill power
1500 W
Hot air power
1600W
Microwave output power
1000 W
Microwave frequency
2450 MHz
Exterior dimensions (WHD)
595  455  542 mm
Interior dimensions (WHD)
420  210  390 mm
Oven capacity
32 ltr
Weight
35 kg
19. INSTALLATION INSTRUCTIONS
19.1. Before installation
Check that the input voltage indicated
on the rating plate is the same as the
voltage of the power outlet you are
going to use. The rating plate is
located on the front part of the cavity
and it is only visible after opening the
door.
If required by the National Electrical
Code (or Canadian Electrical Code),
this appliance must be installed on a
separate branch circuit.
Installer – show the owner the location
of the circuit breaker or fuse. Mark it
for easy reference.
Before installing, turn power OFF at
the service panel. Lock service panel
to prevent power from being turned
ON accidentally.
Be sure your appliance is properly
installed and grounded by a qualified
technician. Installation, electrical
connections and grounding must
comply with all applicable codes.