Problem Possible cause Remedy
The lamp does not
operate.
The lamp is defective. The lamp has to be replace.
There is sparking in
the cavity.
There are metal dishes or dishes
with metal trim.
Remove the dish from the appli-
ance.
There is sparking in
the cavity.
There are metal skewers or alu-
minium foil that touches the in-
terior walls.
Make sure that the skewers and
foil does not touch the interior
walls.
The turntable set
makes scratching or
grinding noise.
There is an object or dirt below
the glass cooking tray.
Clean the area below the glass
cooking tray.
The appliance stop to
operate without a
clear reason.
There is a malfunction. If this situation repeats call the
Authorised Service Center.
11.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service centre
is on the rating plate. The rating plate is
on the appliance. Do not remove the
rating plate from the appliance.
We recommend that you write the data here:
Model (MOD.) ........................................
Product number (PNC) ........................................
Serial number (S.N.) ........................................
12. INSTALLATION
WARNING!
Refer to Safety chapters.
12.1 General Information
CAUTION!
Do not block the air vents. If
you do that, the appliance
can overheat.
CAUTION!
Do not connect the
appliance to adapters or
extension leads. This can
cause overloading and risk
of fire.
CAUTION!
The minimum installation
height is 85 cm.
• The microwave is for a kitchen
counter top use only. It must be
placed on a stable and flat surface.
• Put the microwave far away from
steam, hot air and water splashes.
• If the microwave is to close to the TV
and radio it may cause interference in
the received signal.
• If you transport the microwave in cold
weather, do not activate it
immediately after the installation. Let
is stand in the room temperature and
absorb the heat.
www.aeg.com34
To Next Page
Loading...
Need help?
General
