AEG MRC 4121 - Page 74

English
74
Turning off the Alarm
Press the
button (9) to stop the alarm.
Automatic Alarm Interval
• Theautomaticallysetalarmfunctioncanbeshutoffforapproximately9minuteswith
the DIMMER / SNOOZE/SLEEP button (4).
• Toturnoffthealarmfunctionfor9minutes,youcanalsopassyourhandovertheinfra-
redsensors.Thedistancebetweenyourhandandthesensorsshouldbemax.10cm.
NOTE:
If the Snooze function is activated, the corresponding point at AL1 or AL 2 flashes. The
infrared sensors are then deactivated.
Deactivate the Alarm Function
To deactivate the alarm function, keep the ALARM1 button (2) or ALARM2 button (3)
pressed. The point at AL1 (17) or AL2 (12) disappears.
Delayed Shut-Off
You can use the function for delayed power-off with radio operation. The unit is switched
off automatically when the selected time is reached.
• SelectthetimeafterwhichtheunitisswitchedoffbyrepeatedlypressingtheDIMMER
/ SNOOZE/SLEEP button (4). The following selections can be made: 90, 60, 30, and 15
minutes. The OFF setting
deactivates this function.
• Thisfunctioncanbecancelledwiththe
button (9).
NOTE:
Hold your hand over the infrared sensors for 2 seconds to activate the function
(90 minutes). However, you can only change the time and deactivate the function
using the DIMMER / SNOOZE/SLEEP button.