10
PRELIMINARY STARTING: FIRST USE
− After filling up the water reservoir, open the steam/water cock as it is
shown in the figure.
− Switch the espresso machine on by keeping the on-off/stand-by button
pressed until the red LED stops flashing and is kept on. This indicator will
signal the operating condition of the machine (flashing: STAND-BY; lit ON;
out OFF).
− At the same time the red indicator of heating will be on; this LED indicates
the heating phase of the water inside the boiler. Now pressing the key as it
is shown in the figure will enable the machine to dispense some hot water,
then wait until the air inside the boiler has completely exhausted through
the steam/water nozzle.
Downloaded from CoffeeMachineManual.com Manuals
To Next Page
Loading...
