AEG RCB636E3MW - Defrosting; Transportation and Changing of Installation Position; Repositioning the Door

EN -29-
Defrosting
Your refrigerator performs automatic defrosting. The water formed as a
result of defrosting passes through the water collection spout, flows into
the vaporisation container behind your refrigerator and evaporates there.
• Make sure you have disconnected the plug of your refrigerator
before cleaning the vaporisation container.
• Remove the vaporisation container from its position by removing
the screws as indicated. Clean it with soapy water at specic time
intervals. This will prevent odours from forming.
Evaporating
tray
Replacing LED Lighting
To replace any of the LEDs, please contact the nearest Authorised Service Centre.
Note: The numbers and location of the LED strips may change according to the model.
TRANSPORTATION AND CHANGING OF
INSTALLATION POSITION
Transportation and Changing Positioning
• The original packaging and foam may be kept for re-transportation (optional).
• Fa󰀬en your appliance with thick packaging, bands or 󰀬rong cords and follow the
in󰀬ructions for transportation on the packaging.
• Remove all movable parts (shelves, accessories, vegetable bins, and so on) or x them
into the appliance again󰀬 shocks using bands when re-positioning or transporting.
Always carry your appliance in the upright
position.
PART - 5.
Repositioning the Door
• It is not possible to change the opening direction of your appliance door if door handles
are in󰀬alled on the front surface of the appliance door.
• It is possible to change the opening direction of the door on models without handles and
models with handles mounted on the sides.
• If the door-opening direction of your appliance can be changed, contact the neare󰀬
Authorised Service Centre to change the opening direction.