12 www.aeg.com
6. BEFORE FIRST USE
INSTALLING WATER LINE
1. For models with Automatic Ice
Maker
– The water pressure should be
2.0~12.5 kgf/cm2 or more to run
the Automatic Ice Maker.
– Check your tap water pressure.
If a cup of 180 cc is full within 10
seconds, the pressure is appropri-
ate.
– If the water pressure is not high
enough to run the Automatic Ice
Maker, call the local plumber to
get an additional water pressure
pump.
2. When installing the water tubes,
ensure they are not close to any hot
surfaces.
3. The water lter only “lters” water. It
does not eliminate any bacteria or
microbes.
4. The lter life depends on the
amount of use. We recommend
you replace the lter at least once
every 6 months. When attaching the
lter, place it for an easy access (to
remove and replace).
Note: After 6 months of rst
power input, icon is ickering. To
eliminate the icon ickering, press
the light button for 3 seconds
after exchanging the water lter.
5. After installing refrigerator and water
line system, select WATER on your
control panel and press it for 2–3
minutes to supply water into the
water tank and dispense water.
To Next Page
Loading...
Need help?
General
