10. Screw the bottom hinge on the other
side of the appliance.
11. Install the rubber support on the side
with no hinge.
12. Fit the door on the lower hinge
making sure the hinge pin enters the
door bottom hole.
13. Install the upper hinge on the
opposite side of the appliance. Fit the
upper hinge pin into the door upper
hole. Tighten the screws.
14. Screw the remaining 2 screws on the
top side of the appliance with no
hinge.
15. Place the top cover on the appliance
and tighten the screws on the back.
Install the door equipment.
Wait at least 4 hours before connecting
the appliance to the power supply.
3.6 Installation of a door
handle
If there is a door handle separately
provided in a bag, you can install it as
follows:
1. Remove the screws from the holes
on the side of the door. Keep or
install the screw covers on the side
with a door hinge.
2. Match the handle holes with the
holes in the door and screw the
handle with screws previously
removed.
4. OPERATION
4.1 Switching on
1. Insert the plug into the wall socket.
2. Turn the temperature regulator
clockwise to a medium setting.
4.2 Switching off
To turn off the appliance, turn the
temperature regulator to the "0" position.
You can also unplug the appliance.
www.aeg.com10
To Next Page
Loading...
Need help?
General
