9.5 Detaching the worktop
2
3
1
To remove the worktop, please proceed
as follows:
• Unscrew the left and the right screws
at the back.
• Push the worktop backwards and lift it
up.
• Store the screws in a safe place to-
gether with the worktop.
9.6 Fitting and mounting to continuous worktop
Before fitting, change the door opening
direction if necessary (see: Door reversi-
bility).
• Push the appliance carefully into the
niche.
• Take care that the mains cable is not
jammed in.
• Check distance from wall (see: Instal-
ling under a continuous worktop).
• Level the appliance by screwing the
two adjustable feet at the front in or
out, thus ensuring a stable position.
• With a suitable screws (depending on
the design of the worktop and the dis-
tance between the appliance and the
worktop, not supplied), fix the appli-
ance under the worktop through the
upper door hinge. If necessary, equal-
ize the gap between the door hinge
and the worktop with a suitable wash-
er (plastic or wood, not supplied). This
will prevent bending of the hinge and
possible failure of door function.
ENGLISH 33
To Next Page
Loading...
