ENGLISH 7
5. INSTALLING YOUR NEW APPLIANCE
This section explains the installation of
the new appliance before using it for the
first time. We recommend reading the
following tips.
WARNING!
For proper installation, this
refrigerator must be placed on a
level surface of hard material that
is the same height as the rest of
the flooring. This surface should
be strong enough to support
a fully loaded refrigerator, or
approximately 266 lbs. (120 kg).
When moving, be sure to pull out
and push back the unit in straight.
Class Symbol
Ambient
Temperature
rage(°C)
Extend
Temperate
SN +10 to +32
Temperate N +16 to +32
Subtropical ST +16 to +38
Tropical T +16 to +43
Leveling of appliance
For proper leveling and avoid vibration,
this appliance is provided with adjustable
feet in front. Please adjust the level by
following below instructions:
1. Roll the refrigerator into place.
2. Turn the adjustable feet (with your
ngers or a suitable spanner) until they
touch the oor.
3. Tilt back the top backwards for about
10-15 mm by turning the feet 1~2 turn
further. This will allow the doors to self-
close and seal properly.
4. Whenever you want to move the
appliance, remember to turn the feet
back up so that the appliance can roll
freely. Reinstall the appliance when
relocating.
Front roller
Rear roller
10-15mm
Adjustable foot
WARNING!
The rollers, which are not castors,
should be only used for forward
or backward movement. Moving
the refrigerator sideways may
damage your oor and the rollers.
This appliance is sold in France. In
accordance with regulations valid in
this country it must be provided with
a special device (see figure) placed in
the lower campartment of the fridge to
indicate the coldest zone of it.
To Next Page
Loading...
