symbol or coloured green and
yellow.
2. Connect the wire coloured blue to the
terminal either marked with the letter
“N“ or coloured black.
3. Connect the wire coloured brown to
the terminal either marked with the
“L“ or coloured red.
4. Check that no cut, or stray strands of
wire is present and the cord clamp
(E) is secure over the outer sheath.
Make sure the electricity supply
voltage is the same as that indicated
on the appliance rating plate.
5. Switch on the appliance.
The appliance is supplied with a 13 amp
fuse (B). In the event of having to
change the fuse in the plug supplied, a
13 amp ASTA approved (BS 1362) fuse
must be used.
WARNING!
A cut off plug inserted into a
13 amp socket is a serious
safety (shock) hazard.
Ensure that it is disposed of
safely.
3.4 Ventilation requirements
The airflow behind the appliance must be
sufficient.
5 cm
min.
200 cm
2
min.
200 cm
2
CAUTION!
Refer to the installation
instructions for the
installation.
3.5 Installing the SpinView
®
shelf
CAUTION!
Clean the accessory with a
soft moist cloth before first
use. Maximum load allowed
on the shelf is 15 kg.
1. Remove one of the glass shelves
from the fridge.
2. Remove the back trim from the glass
shelf
3. Slide in the SpinView
®
clamps on the
glass shelf's back edge.
4. Mount the SpinView
®
shelf. Make
sure that the clamp pins fit into
special indentations at the base of
the shelf. Check if the SpinView
®
shelf is mounted properly by moving
it gently forwards and backwards.
5. Place the shelf with the clamps inside
the fridge. Push the shelf until the
clamps lock inside the compartment.
ENGLISH 9
To Next Page
Loading...
