• Always keep the airflow slots at the
bottom of the appliance clear.
• Make sure there is good airflow where
the appliance is to be installed.
9.2 Adjustment of default
dryness level
To change the default dryness level:
1. Turn the appliance on.
2. Wait approximately 8 seconds.
3. Select 1 of the available
programmes.
4. Touch and hold down the Nivel de
Sec. and Anti-arrugas/rugas buttons
at the same time.
One of the symbols appears on the
display:
- Maximum dryness
- Extra dryness
- Standard dryness
5. Touch the Inicio/Pausa button
repeatedly until you reach the
desired dryness level.
Dryness lev-
el
Display symbol
Maximum
dryness
Extra dry-
ness
Standard
dryness
6. To memorise the setting touch and
hold down the Nivel de Sec. and
Anti-arrugas/rugas buttons at the
same time for approximately 2
seconds.
9.3 Deactivating the tank
indicator
The water container indicator is activated
by default. It illuminates at the end of the
drying cycle or during the cycle if the
water reservoir is full. If the draining kit is
installed the water container is drained
automatically and the indicator can be
deactivated.
To deactivate the indicator:
1. Turn the appliance on.
2. Wait approximately 8 seconds.
3. Select 1 of the available
programmes.
4. Touch and hold down Anti-arrugas/
rugas and Tiempo/Tempo buttons
at the same time.
One of 2 configurations is possible:
• the tanque/depósito indicator:
is on if the symbol
appears - the water container
indicator is permanently
activated
• the tanque/depósito indicator:
is off if the symbol
appears - the water container
indicator is permanently
deactivated
10.
CARE AND CLEANING
10.1 Cleaning the filter
At the end of each cycle the
filtro
symbol comes on the display and you
must clean the filter.
The filter collects the lint
during the drying cycle.
To achieve the best drying
performances clean the filter
regularly , clogged filter lead
to longer cycles and energy
consumption increase.
Use your hand to clean the
filter , and if necessary , a
vacuum cleaner .
ENGLISH 17
To Next Page
Loading...
