2. Pull the plastic connection out and
drain the water into a basin or
equivalent receptacle.
3. Push the plastic connection back in
and place the water container back
into position.
4. To continue the programme press
the Inicio/Pausa button.
10.3 Cleaning the condenser
If the symbol
condensador
flashes on
the display, inspect the condenser and
its compartment. If it is dirty, clean it. Do
the check not less than once a 6 months.
WARNING!
Do not touch the metal
surface with bare hands.
Risk of injury. Wear
protective gloves. Clean
carefully to avoid damaging
the metal surface.
To inspect:
1. Open the door. Pull the filter up.
2. Open the condenser cover.
3. Turn the lever to unlock the
condenser lid.
4. Lower the condenser lid.
5. If necessary, remove the fluff from
the condenser and its compartment.
You can use a vacuum cleaner with
the brush attachment.
6. Close the condenser lid.
www.aeg.com20
To Next Page
Loading...
