Need help?Do you have a question about the AEG Vampyr 6000 and is the answer not in the manual?
General| Brand | AEG |
|---|---|
| Model | Vampyr 6000 |
| Category | Vacuum Cleaner |
| Language | English |
Guided on both sides with hinge and lid necks. Remove by raising lid and pressing flaps outward.
Press key to the front using a screwdriver between lid and key. Take out the spring wire.
Press the 2 clips of the lid upward one after the other using a small screwdriver while moving that piece forward.
Guided with 2 necks (axes) on both sides. Press the lid in the middle of its front side down.
The lid leaps up, press the 2 guiding necks inward and pull the lid up.
Put a small screwdriver into the support, unlock it and press it down.
Apply the screwdriver inside and press outward.
The keys are snapped twice each. Raise and/or remove the lid completely when performing these activities.
Unlock the snap-in catches, which are each snapped in twice on the left and right side.
Press the key and put the screwdriver between the key and panel, apply to snap-in catches and press outward.
Can be taken off and mounted on again. Mounting on the printed panel locks the keys.
Unlock the control panel, take off the rocker switch, put it in again with adjusting spring.
Insert the gear wheel into the sliding part with the slide potentiometer and apply it in the center.
Lever the slider using a screwdriver between slider and panel. Put in the angle spring into the neck.
Expand the support (2 legs) using circlip pliers.
Unscrew the 7 screws (1 of them below the microfilter box).
Press from outside to inside and unlock.
Unlock the neck in the middle with pliers or another screwdriver.
Press up the snap-in catch in the cable roller box and move outward. Unhinge the hang-in catches.
Push out of the guide upward. During assembly, the stopper must be adjacent below outside the support part.
Unlock the 3 catches and pull them through downward.
To Next Page
