9
g. Insert one of the 1” rubber mounts (1228599) into
the indicated area. Secure with a supplied 6mm
fender washer and serrated nuts.
h. Insert the upper inlet pipe (2-6831) into the previ-
ously installed reducer coupler on the throttle body.
The end of the inlet pipe closest to the PCV nipple and
MAF adapter should install into the throttle body cou-
pler. Secure in place with a hose clamp (9452).
i. Slide the upper inlet pipe’s bracket onto the previ-
ously installed rubber mount; loosely secure with a
6mm washer and nut.
j. Install the MAF sensor with the factory hardware;
connect the wire harness to the MAF sensor.
k. Connect the other end of the ½” hose to the upper
inlet pipe’s nipple and secure with the provided hose
clamp (99024.032).
To Next Page
Loading...