8 aeno.com/documents
Button Panel Control (See Figure b)
The room air quality indicator/timer display shows either the room air
quality or the time period during which the purifier is switched on. The
indicator indicates that ultraviolet air purification process is ongoing. The
speed button allows you to change the fan speed of the purifier every time
you press it (The fan speed will be displayed by the air speed indicator ).
The “Start/Stop” button is used to switch the purifier on and off. The Sleep
Mode button is used to switch the purifier into the Sleep Mode at a minimum
fan speed where all indicators go out except for the Sleep Mode button. To exit
this mode, press the button again. The Automatic Mode button is used to
start one of the three available modes of operation of the purifier based on the
room air quality. The Wi-Fi button is used to activate the Wi-Fi Module of the
purifier to control it remotely from a smartphone. For more information, see
the AENO app connection process described in the User manual available at
aeno.com/documents. The indicator changes its colour depending on the
level of air pollution by organic compounds (glues, paints, varnishes, solvents,
etc.). The timer button is used to switch the air quality indicator to the timer
mode. By additional clicks on this button, you may set the timer for the purifier
operation: from 1 to 24 hours. The Child Lock button will be activated, if
pressed and clicked for 3 seconds. As a result, all buttons become unavailable
for control. To enable the buttons, you need to press and hold this button for 3
seconds again. The ioniser button is used to switch on the ionizer which
helps to remove unpleasant odors. The filter reset button indicates the time
to replace the HEPA filter. Press and hold this button for 10 seconds to stop
flashing, the timer set for the service life of the HEPA filter will start from zero.
To Next Page
Loading...