aeno.com/documents 7
detergents to clean the device. Do not dispose of the device with unsorted
urban waste, because this will be harmful for the environment. For more
information on proper disposal, please contact your local waste collection and
disposal company. Keep children away from the device. There is a risk of serious
injury and electric shock. This device is intended for use by adults only.
Warnings, precautions, and instructions contained herein may not contain
every possible hazardous situation. Please use common sense when operating
the device.
Components of the Air Purifier (See Figure a)
(1) – Air inlet, (2) – Removable front panel, (3) – HEPA filter, (4) – Plastic plugs, (5)
– Purified air outlet, (6) – Casing, (7) – Mounting screws, (8) – Support, (9) – Wall
mounting bracket.
Initial Setup (See Figure a)
Before operation, you should remove the packaging from the HEPA filter. To
do this, first make sure that the air purifier is unplugged. Then, carefully remove
the front panel (2) and pull the HEPA filter (3) out using the fabric strips. Remove
the filter packaging and insert the HEPA filter (3) back into the device body. Close
the front panel (2).
There are two options to install the purifier as follows:
• On the support: Insert the plugs (4) in the open ends of the support (8).
Attach the support with the three mounting screws (7) to the purifier casing
(6).
• On the wall: Attach the wall bracket (9) to the wall as desired (at a height of
at least 170cm from the floor). Screw the three mounting screws (7) into the
back of the purifier casing (6). Insert the heads of the mounting screws (7) on
the back of the purifier into the grooves of the wall bracket (9) attached to
the wall.
To Next Page
Loading...